It is a really simple task to drill through the ceramic tile on a wall. It can be done with just one tool and in less than 10 minutes! If you need to know how then keep reading. We will discuss 3 steps that will show you how to drill through the ceramic tile on a wall, so make sure you read it all the way through.

The 3 Easy Steps: How to Drill Through Ceramic Tile on a Wall

There are 3 easy steps that you can follow to learn how to drill through the ceramic tile on a wall. The steps are very simple, and do not require much time or effort at all, which makes this task so easy!

Step One

You will need a hole saw for this step. You can use a smaller one if you only want to make the small holes in your ceramic tile, but it is recommended that you get a bigger size since these tiles are not very thick and tend to break easier than other types of flooring materials might.

Step Two

Once you have put your drill into reverse mode on any setting between low and high power depending on how much pressure you feel comfortable using, then start drilling through the tile at medium speed until half of the hole is cut out.

Step Three

Then switch to forward gear so that both cutting disks go in together, sliding them back and forth while rotating the drill until you have cut through the tile.

Step Four

Then turn off your drill and remove all of the ceramic tiles that you have just cut, being careful to keep them intact so they can be used again if needed at a later time.

You now know how to drill through the ceramic tile on a wall! It is a really simple task when you follow these steps correctly, but it is extremely important not to go too fast or push down hard while drilling since this could cause other problems for different reasons such as cracking or chipping the drywall behind the tile, which will make it more difficult for you if any repair work needs to be done later on.

If there are no studs where you want to put up some new walls, then you will need to install some on the drywall. This can be quite a difficult task, and it takes some time, but if done correctly, your new walls should hold up for many years without causing any problems or structural damage.

You might also want to consider purchasing an additional circular saw blade that has diamond edges so you can cut all of your tiles out quicker than with just one blade. If this is not something you are interested in doing, then the standard version should work fine since they will still do a great job at cutting through ceramic tile materials.

To save yourself from having to spend money buying several different blades, we advise that you use only one hole saw bit when drilling into the wall because these bits have cutting disks that work similarly to the circular saw blades we just talked about.

Step Five

You can now remove all of the ceramic tiles and cut out a hole for your wall studs if needed.

Conclusion

The steps above are easy to follow, and they show you how to drill through the ceramic tile on a wall. If you follow them correctly, then your new walls should be up in no time! You can also check our post on how to drill through angle iron and how to drill through the foundation wall.