This article will show you how to install casters on Craftsman tool chest. If you’re in the market for a new tool chest, but don’t want to spend a fortune, then you should consider getting one from Craftsman.

You’ll need some basic tools and supplies that are easy to find at any hardware store. If you’re in the market for a new tool chest, but don’t want to spend a fortune, then you should consider getting one from Craftsman.

How To Install Casters On Craftsman Tool Chest In 7 Steps

Step 1: Remove the two screws on the bottom of the tool chest

The first step is to remove the two screws on the bottom of the tool chest. This will give you access to the caster sockets.

Step 2: Insert the caster socket into the hole

The second step is to insert the caster socket into the hole. Make sure that it is facing in the correct direction before proceeding.

Step 3: Hammer in place

The third step is to hammer in place. You may need to use a little bit of force, but be careful not to damage anything else in the process.

Step 4: Replace screws

The fourth step is to replace screws. Make sure they are tight so that they do not come loose over time.

Step 5: Repeat on other side

The fifth step is to repeat on another side. You may want to have a friend help you so that the caster sockets are even and line up with each other perfectly.

Step 6: Place casters in socket

The sixth step is to place casters in the socket, if they do not fit easily then make sure that you placed the caster into the right position already because it can only go one way. Remember which direction was correct based on how easy or hard it was for you to put them together by placing them this time around as well.

Step 7: Enjoy your new Craftsman tool chest!

The last step is simply to enjoy your new Craftsman tool chest! Sit back and relax knowing that your tools will be safe from on no matter what happens during their time in storage.

Tips When Installing Casters:

1. Make Sure To Measure The Size Of Your Casters Before Purchasing

The first tip is to measure the size of your casters before purchasing. This will ensure that you purchase ones that are compatible with your tool chest, otherwise, they may not fit or work properly once installed.

2. Ensure That You Purchase Heavy Duty Ones To Protect Your Tool Chest Over Time

The second tip is to ensure that you buy heavy-duty casters for durability over time so that it can hold up against possible damages and wear and tear as well. Otherwise, consider what material would be best suited for this purpose based on how often it will be used in order to find something more durable than plastic if needed at all times.

3. Make Sure They Will Fit Through The Holes In Your Craftsman Tool Chest

The third tip is to make sure they will fit through the holes in your Craftsman tool chest. This way you won’t have to drill new ones or modify anything else along the way as well.

You don’t want a mistake here since it could cause further issues with damaging tools and other materials inside of this space if not done properly from the start.

4. Lubricate The Caster Socket With WD-40/Lube

The fourth tip is to lubricate the caster socket with WD-40/Lube for easier installation down the line. This will help it to glide in and out of the hole more easily, preventing any sort of damage from happening as well. Just make sure that you are careful while doing this since excess can cause other problems down the road if not cleaned up properly.

5. Don’t Over Tighten The Screws Or You Could Damage Chest

The fifth and final tip is to don’t over tighten screws or you could damage the chest. Overtightening may seem like a good way to ensure that everything stays in place, but it can actually lead to some issues down the line. If screws are too tight, you could damage your chest making it unusable for storage or other purposes over time as well.

Suggested Post

• How To Make A Shop Vac Quieter: 6 Easy Ways
• How to Organize Sockets in Tool Bag: 5 Tips for Organizing