Most people know that a Milwaukee cordless drill is an amazing tool. The one thing they may not know, however, is there are certain things you can do to make it last longer and perform better.

Brushes are one of the most important parts of your Milwaukee cordless drill and it’s a good idea to replace them when they wear out – which happens over time with use. In this post, we will show you 8 steps on how to replace brushes on a Milwaukee cordless drill!

How To Replace Brushes On A Milwaukee Cordless Drill in 8 Steps

Step 1: Remove the battery

The first thing you need to do is remove the battery. This can be done by pressing down on the release button and pulling it out of the drill.

Step 2: Remove the chuck

The second step is to remove the chuck. You can do this by unscrewing it in a counterclockwise direction.

Step 3: Unscrew the screws that hold the casing together

Once you have removed the chuck, you need to unscrew the screws that hold the casing together. These are located on either side of the drill.

Step 4: Lift off half of the casing

After you have unscrewed these screws, you need to lift off half of the casing. Be careful to lose any of the screws as you lift it off.

Step 5: Remove the brushes and spring clip

The fifth step is to remove the brushes and spring-loaded metal pressure plate, also known as a “spring clip”. This can be done by first removing the old brush from one side of your drill bit using tweezers or needle-nose pliers. You then place that against another set of new ones so you know exactly where they should sit when reinserted into their proper position.

Then take out all three parts (old brush + two fresh replacements) at once with your other hand’s thumb pressed firmly on top of them while holding onto each one individually with your index finger along its length. Be sure not to lose any pieces during this process, especially if small!

Step 6: Install the new brushes

Now it’s time to install the new brushes. This is done by inserting them into their housing on the drill, making sure that each brush is facing in the correct direction (with the bristles pointing downwards).

Step 7: Reattach half of the casing

Now you need to reattach half of the casing. Be sure that all four screws are put back into their original holes and tightened securely before doing so!

Step 8: Put everything back together (reverse steps)

The final step is to follow these instructions backward, putting everything back together again. The last thing you should do after screwing on both halves of your drill’s housing is replacing its chuck by tightening it in a clockwise direction until it locks into place.

Now just pop your battery pack back into your drill, press down on its release button, slide it inside, and lock it shut with another push-button locking mechanism at either side of the handle. Congratulations! You have installed new brushes onto your Milwaukee cordless drill.

Suggested Post

• How to Remove Stuck Bit in Milwaukee Impact Driver: 6 Basic Steps
• How to Spot a Fake Dewalt Battery: 6 Basic Ways to Tell