##### Share

- 7 Steps On How to Use Empire Stainless Steel Protractor
- Step 1: Find the center of the protractor
- Step 2: Place your object of interest at the edge of the protractor
- Step 3: Measurement Points
- Step 4: Draw a line connecting the two points
- Step 5: Read off the angle at each point where lines intersect!
- Step 6: Reverse process for depression measurements!
- Step 7: Practice makes perfect!

- Suggested Post

The Empire Stainless Steel Protractor is a precision instrument used to measure the angle of elevation or depression.

It is an indispensable tool for various applications in surveying, construction, engineering, and navigation. This article will show you 7 simple steps on how to use empire stainless steel protractor!

If you are interested in using this product for any of these purposes, you must know how to properly use it.

**7 Steps On How to Use Empire Stainless Steel Protractor**

**Step 1: Find the center of the protractor**

The first thing you need to do is find the center of the protractor. This can be done by placing it on a flat surface and folding it in half. The crease will mark the center point.

**Step 2: Place your object of interest at the edge of the protractor**

Next, place your object of interest at the edge of the protractor so that one end rests on the vertex while the other end hangs over the edge. Make sure that both points are touching and there is no space between them.

**Step 3: Measurement Points**

Now take note of where each measurement point falls in relation to your object of interest. There should be six measurement points in total- three on either side. Be as precise as possible when marking these points.

**Step 4: Draw a line connecting the two points**

Take your ruler and draw a straight line that connects both of the measurement points. Make sure to use light, smooth strokes as this will make it much easier when you begin drawing angles later on in step five.

**Step 5: Read off the angle at each point where lines intersect!**

Now we can finally read off all those numbers we’ve been marking down for such a long time now! The number located directly below one end of your object is what you should be reading right now.

That’s how much elevation or depression that side has compared to horizontal level/zero degrees (which would be represented by zero). However, if there are any other numbers, those indicate vertical measurements; the number located directly below the vertex is how far up or down that side of your object is relative to horizontal level/zero degrees.

**Step 6: Reverse process for depression measurements!**

Now it’s time to do a reverse calculation in order to find out if you have any elevation on either side of your object. First, locate the vertical measurement point closest to zero and make a note of its value- this will be called “A”.

Next, take one end of your object with which you made all those points back when we started measuring angles and place it at that same spot again (the CenterPoint).

Now measure from there towards where one line intersects with another using both sides- call these new numbers “B” and “C”. Finally, take the difference between “B” and “C”, divide by two, and you will have your answer!

**Step 7: Practice makes perfect!**

Remember that practice truly does make perfect when it comes to using a protractor. The more time you spend with one of these tools in hand, the better chance you’ll become an expert user someday soon. So try practicing this process on as many angles as possible until it becomes second nature to you- which won’t be long now!

Congratulations, now go out there and use empire stainless steel protractor like a boss! Thanks for reading along everyone; we hope that our guide has been helpful so far. Keep checking back here for even more great content from us about how to use all sorts of different tools and products!

**Suggested Post**

- How to Use a Titan 400 Paint Sprayer: 6 Basic Steps
- How to Use a Ryobi Infrared Thermometer in 7 Tips

## 0 Comments